Description

Description: 4DR XM Enclosures

Richards Electric Motor Co. has been designing and fabricating Industrial and Commercial Electrical Control Panels and Automation Systems for a multitude of industries/applications for over 40 years.

Application:
Designed to house electrical equipment and provide protection from dirt, dust, oil, and water and to house most standard type disconnects. For outdoor application, a drip shield and drain vent are recommended.

Construction: 

• 0.125 In. carbon steel.
• Seams continuously welded and ground smooth.
• Flange trough collar around all sides of the door opening.
• Body stiffeners in large enclosures for extra rigidity.
• Heavy-duty lifting eyes anchor into the reinforced top.
• Removable center posts permit easy panel installation.
• Concealed hinges.
• Black zinc die-cast coin proof/padlocking handle on the main door with black zinc die-cast padlocking handle on slave doors.
• 3-point latching mechanism.
• The ends of latch rods have ramp shoes for easier door closing.
• Panel supports.
• Large removable print pockets.
• Pour in place oil & water-resistant gasket
• Removable panels mount on collar studs.
• The master door is the far right-hand door on all enclosures.
• Defeater on the master door requires a screwdriver to open.
• Mechanical interlock activated by master door prevents slave doors from being opened first. Doors can be closed in any order.
• Ground stud on door and body.
• Provisions for the light kit.
• Holes plugs provided to seal holes in the bottom of the enclosure.

Finish: ANSI-61 gray powder coating inside and out. Sub-panels are powder-coated white.
Part numbers ending in “G” have galvanized subpanels installed.

Industry Standards -(IS4)

• NEMA Type 3R, 4, 12, and Type 13
• UL Listed Type 3R, 4 and 12
• CSA Type 3R, 4 and 12
• IEC 60529
• IP 55

Notes: Disconnect switch (or circuit breaker) and operating mechanism are not furnished with enclosure.

*Part numbers ending in “G” have galvanized sub-panels installed.

Special Instructions apply for IS3, IS4, and IS6 to maintain the environmental rating of Type 3R for these parts. Instructions are located on the enclosure door. A drip shield is required on IS3, a drip shield is recommended on IS4 and IS6. Drain holes are required on all.

Part Number: SCE-84XM4EW18, SCE-84XM4EW18G, SCE-84XM4EW24, SCE-84XM4EW24G, SCE-90XM4EW18, SCE-90XM4EW18G, SCE-90XM4EW24, SCE-90XM4EW24G,