Clamp Fastened Single Door Enclosures For Flange-Mounted Disconnects

Description

Description: HS LP Enclosures

Richards Electric Motor Co. has been designing and fabricating Industrial and Commercial Electrical Control Panels and Automation Systems for a multitude of industries/applications for over 40 years.

Application:
Designed to house electrical and electronic controls, instruments, and components. Provides protection from dust, oil, and water. Designed to house most standard type disconnects. For outdoor application, a drip shield and drain vent are recommended.

For details about the design, performance expectations, applications, and design suggestions – See Design Considerations www.saginawcontrol.com/instman/considerations.pdf

Construction:

• 0.075 In. carbon steel.
• Seams continuously welded and ground smooth.
• Concealed hinges.
• Door clamps are quick and easy to operate.
• Flange trough collar around all sides of the door opening.
• Interior print pocket.
• Collar studs 3/8-16 provided for mounting optional panels.
• Pour in place oil & water-resistant gasket
• Disconnect cutout provided on the flange.
• Ground stud on the door.
• No stiffener required.
• External mounting provision top and bottom of the back.

Finish:

ANSI-61 gray powder coating inside and out. Optional panels are powder-coated white.

Industry Standards -(IS4)

• NEMA Type 3R, 4, 12, and Type 13
• UL Listed Type 3R, 4 and 12
• CSA Type 3R, 4 and 12
• IEC 60529
• IP 66

 Notes: Disconnect switch (or circuit breaker) and operating mechanism are not furnished with this enclosure.
Provision for Lifting Lugs included on enclosures with Height >48″ and with Depth >16″. The Lifting Lug assembly will be included with the enclosure bolt pack and hole plugs provided to seal holes in the bottom of the enclosure.
Special Instructions apply for IS3, IS4, and IS6 to maintain the environmental rating of Type 3R for these parts. Instructions are located on the enclosure door. Drip shield is required on IS3, a drip shield is recommended on IS4 and IS6. Drain holes are required on all.

Part Number: SCE-24HS2108LP, SCE-24HS2508LP, SCE-30HS2508LP, SCE-36HS2508LP, SCE-36HS3108LP, SCE-36HS3112LP, SCE-42HS3112LP, SCE-42HS3712LP, SCE-48HS3712LP, SCE-60HS3712LP,